Hey everyone, I'm new to this site.
I have a Torchmate II on a 5 x 10 table that i"ve owned for 4 or 5 years. Over all I been really pleased. But... today I had a new experience and it happen right after Torchmate Techs left for the day.
I was cutting a fairly detailed design, which if cut in half, each side would mirror the other. Everything all lined up and looking good, so I start the cut. Then as I'm cutting half of the design cuts a 1/4" lower. It shifted somehow. Anyway it screwed me up. Has anyone else ever had cut lines shift during cutting?